|
||||
News and Information about the Test of Electronics in Research & Design, Production, Maintenance, and Installation. | ||||
Main MenuNewsletterNews AreaInfo AreaWeblinksProduct Focus |
Readers Top 5 News of last 30 days
Latest Test and Measurement News
Current Probe for measuring Currents in PCB Tracks directly16 July 2013 - The Aim I-prober 520 positional current probe uses a patented technology to observe and measure current without the need to break or surround the conductor. The I-prober 520 is a compact hand-held probe which is used with an oscilloscope. By placing the insulated tip of the probe onto a PCB track, the current flowing in the track can be observed and measured. Calibrated measurement of current normally requires either the insertion of a shunt resistor, or for the conductor to be passed through a closed magnetic loop. Typically this is done using some form of split clamp device. Whereas this is suitable for individual wires, it is of no use for measuring current in PCB tracks. The probe has a bandwidth of DC to 5MHz and a dynamic range of 10mA to 20A pk-pk. It is safety rate to 300V Cat II (600V Cat I) and is suitable for connection to any 1 MOhm input oscilloscope. The Aim I-prober 520 operates by sensing the field in very close proximity to the track. To achieve a calibrated measurement, the field sensor must be capable of maintaining a precise distance from the track. To achieve good sensitivity this distance must be very small because field reduces with the square of distance (to a first order approximation). To create a practical current measurement probe, a very special type of miniaturised sensor was needed. The requirements included very small size with precision dimensions, dc sensing capability, wide ac bandwidth, and low noise. None of the existing sensor technologies used within field and current probes was suitable for this. Instead the I-prober 520 uses a patented miniaturised version of a fluxgate magnetometer, developed in conjunction with Cambridge University. It is the patented miniaturisation that enables it to measure the field at a precise point in space. In addition, the miniature sensor has much lower noise and much wider bandwidth than a conventional fluxgate magnetometer. As well as measuring currents in PCB tracks, the probe can be used on component leads or any other current carrying conductor. An interesting example is ground planes where it can be used to observe circulating currents, interference injection points and hot spots in order to optimise design. The Aim I-prober 520 is supplied with a control box and calibrator, power supply, and a clip on toroid assembly which can convert it into a convention closed magnetic loop current probe. The price is £495, 595 Euros, or US$850. Related Articles: |
Upcoming Events More events...
Tag CloudOscilloscope
JTAG
Boundary Scan
Goepel
PXI
Rohde & Schwarz
Tektronix
Keysight
AOI
Anritsu
National Instruments
Inspection
Teledyne LeCroy
Aeroflex
LTE
Yokogawa
AXI
Spectrum Analyzer
Keithley
In-Circuit-Test
Signal Analyzer
Automotive
EMC-Test
Signal Generator
Advantest
Multitest
B&K Precision
Corelis
Power Supply
SPI
Flying Prober
Teseq
Cognex
Switching
Teradyne
Viscom
Pickering
Fluke
GAO Tek
PCIe
|
||
© All about Test 2018 |